Instructions

30
10. Operation
a) General information
• Check that the correct lter is attached for the task at hand.
• Install any necessary nozzles and tips.
• Make sure that the motor unit (11) is installed properly and securely latched (3).
• Connect the mains plug to a standard mains socket.
• Switch (1) the product ON (On/Off switch to position I).
• Switch (1) the product OFF after use (On/Off switch to position O).
• Disconnect the mains plug from the mains socket.
b) Socket synchronization
You can connect a device to the synchronized power socket (2). If the connected device has a power consumption of
≥ 200 W, the vacuum will automatically switch on and off when the connected device is turned on and off.
The maximum power consumption of the connected device must not exceed 2000 W.
The protection class IP44 of the integrated socket is ensured only if the connected plug also possesses
protection class IP44.
• Connect vacuum to power supply.
• Connect external device to synchronized power socket (2).
• Set the on/off switch to position II (2).
- The product switches on automatically after 2-3 seconds when the connected device is switched on.
- The product switches off automatically after 5-8 seconds when you switch off the connected device.