Manual

7 Product overview
1
2
5
4
3
6
2
7
8
9
10
11
12
13
14
15
16
17
18
19
20
1 Air inlet / vacuum head
(nozzle)
2 Dust cup
3 Motor unit
4 Dust cup release buttons
5 On/Off button
6 Air outlets
7 Groove
8 Notch
9 Filter holder
10 Rib
11 Filter
12 Sponge lter
13 Front tab
14 Crevice tool
15 Scraper
16 Small brush
17 Upholstery nozzle
18 Spray bottle
19 Scrubber head
20 Scrubber pad
8 Assembly / disassembly
Important:
Always switch the power OFF and disconnect the rechargeable battery pack if leaving the
product unattended, when changing accessories, cleaning, or after use.
8.1 Assembly
Important:
Risk of leakage or damage! always check the lter assembly is correctly inserted and
level in the dust cup.
1. Insert the lter (11) into the lter holder (9) by aligning the tabs with the slots. Then turn the
lter clockwise until it locks into place.
Lock
2. Align the rib (10) on the lter assembly (9, 11) with the groove in the back of the dust cup
(7), then rmly push the lter assembly in until it is seated in the dust cup.
3. Put the sponge lter (12) on the motor unit, so that the two holes on the lter are inserted
into the tabs on the motor unit.
4. Tighten the vacuum head (1) on the dust container (2) by turning the ring clockwise.
5. Hold the dust cup (2) at an angle to insert the notch at the bottom into the front tab (13) on
the motor unit. Then push the dust cup onto the motor unit until it snaps into place.
8.2 Disassembly
Important:
Risk of damage! Hold the dust cup before pressing the release buttons, as the dust cup
will tilt out after the buttons are pressed.
1. Remove the rechargeable battery.
2. Hold the dust cup (2) with one hand, and then press the two release buttons (4) on the
handle at the same time to detach the dust cup.
3. Pull out the lter assembly (9, 11) from the dust cup.
4. Discard any dust or liquid from the dust cup.
5. Turn the lter (11) anti-clockwise to remove it from the lter holder (9).
Unlock
6. Remove the vacuum head (1) from the dust container by turning the ring anti-clockwise.
7. Remove the foam lter (12) from the motor unit for cleaning. See section “Cleaning and
care”.
9 Rechargeable battery pack
Important:
For information relating to battery operation and safety, refer to the operating instructions
that come with the battery and charger.
1. Attach attach the battery to the battery port, it should lock into place
2. To remove the battery, press the battery release button.
lock
10 Operation
Keep hair, loose clothing, ngers, and body parts away from openings and moving
parts.
10.1 Vacuuming
1. Attach the desired accessory.
2. Press the On/Off button (5) to turn the vacuum cleaner on or off.
3. If you need to change the direction of the vacuum head, press the On/Off button to turn the
vacuum cleaner off, push the vacuum head down to rotate it left or right (360° rotatable),
and release to lock it in place.