Manual

41
Ifthefasteningelementsarestilljammedafterfollowingtheaboveinstructions,dothefollowing:
• Loosen the four hex head screws on the stapler head using the wrench provided.
• Remove the stapler head, and then remove the jammed fastening element.
• Ifnecessary,removethejammednailwithpliers.
• After the jammed nail has been successfully removed, tighten the stapler head again with the hex head screws.
• Fill the magazine with new nails or staples and check that the device is working again.
11. Troubleshooting
1No function, the appliance does not switch on.
• Thebatteryisdepleted.Chargethebatteryusingthecorrespondingcharger.
• Thebatteryisnotcorrectlyinsertedintothebatterycompartment(11)ontheappliance.
• Theapplianceisoverheated.ChecktheLEDstatusindicator.Lettheappliancecooldown.
• Thenails/staplesarejammed.Removethenail/staple(see“Removingajammednailorstaple”).
• Nonailsorstaplesinthemagazine.Rellstaplesornails.
2The penetration depth is too low.
• Thebatteryisatandshouldberecharged.
• Check the depth setting.
• Theworkpieceistoohard.