User manual

What you must do
1. Stirring
Resin constituents containing fillers (gel
coat, mould resin) should be stirred thorough-
ly before use.
Heating (30 - 40 °C) these constituents in a
water bath or microwave oven accelerates
homogenisation.
Important:
Fillers precipitate out of the mixture!
Cool down to room temperature (23 °C) before
further processing!
2a. Dosing
Resin and hardener constituents should be
dosed as a ratio of weights with ±2 % tole-
rance. Formulations under 20 g can best be
mixed as a ratio of volumes with the dosing
injector.
Important:
Adding more hardener than specified does
not result in faster curing, but poor proper-
ties. Likewise the processing time cannot
be extended when less hardener is added.
On greater deviations the mixture may fail
to cure!
1
2
Fon [phone] t Fax [phone] tXXXSHEF
EPOXY RESIN + HARDENER