Certifications 2

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 886592
Material Safety Data Sheet
7. Handling and storage
7.1. Precautions for safe handling
Advice on safe handling
Measures to prevent aerosol and dust generation It is recommended to design all work processes always so that the following
is excluded: Inhalation of vapours or spray/mists, Eye contact, Skin contact.
Technical ventilation of workplace: Vapours are heavier than air. Provide room air exhaust at ground level. During filling,
metering and sampling should be used if possible: Splashproof grounded devices, Devices with local exhaust, Use only in a
exhaust booth with integrated air filter. Use in ventilated spray booths only. Ensure that fresh air is supplied to the breathing
zone of the operator and exhaust air is removed in his back! Recirculation of exhaust air is not recommended. Always close
containers tightly after the removal of product.
Advice on protection against fire and explosion
Measures to prevent fire:
The product is: Flammable
The formation of combustible vapours is possible at temperatures above: +10 °C (Flash point -15°C).
Vapours can form potentially explosive mixtures with air. Spray mist may be blammalbe at temperatures below the flash point.
Reignition possible over considerable distance. Vapours are heavier than air, spread along floors and form explosive mixtures
with air. Due to danger of explosion, prevent leakage of vapours into cellars, flues and ditches. Provide earthing of containers,
equipment, pumps and ventilation facilities. Use explosion-proof machinery, apparatus, ventilation facilities, tools etc. Use non-
sparking tools. Take precautionary measures against static discharges. Flammable vapours can accumulate in head space of
closed systems. Only use the material in places where open light, fire and other flammable sources can be kept away. Keep
away from sources of heat (e.g. hot surfaces), sparks and open flames. Usual measures for fire prevention. Never use
pressure to empty container. Wear anti-static footwear and clothing.
Further information on handling
Environmental precautions:
Shafts and sewers must be protected from entry of the product. Transfer wash-downs in sealed containers. Provide for
retaining containers, eg. floor pan without outflow. For restriction of emission on volatile organic compounds (VOC) the solvent
vapours should be supplied to an exhaust air purification facility (filter, gas washer, incineration).
Wear personal protection equipment (refer to section 8). Minimum standard for preventive measures while handling with
working materials are specified in the TRGS 500. Observe the general hygiene measures when handling chemical substances.
Working places should be designed to allow cleaning at any time . Floors, walls and other surfaces in the hazard area must be
cleaned regularly. Clean spray booth and exhaust hood completely with every product change. When using do not eat, drink,
smoke, sniff. Thorough skin-cleansing after handling the product. Used working clothes should not be worn outside the work
area.
7.2. Conditions for safe storage, including any incompatibilities
Requirements for storage rooms and vessels
Suitable floor material: Floors should be impervious, resistant to liquids and easy to clean.
Protect against: heat, Cold.
Store only in original container. Storage temperature: +10-+30°C
Keep away from foodstuffs and fodder.
Page 6 of 15