Certifications 2

SAFETY DATA SHEET
according to Regulation (EC) No. 1907/2006 (REACH) and Regulation (EU) No.
2015/830
TOOLCRAFT Zink-Alu-Spray
Material number Zink-Alu-Spray
Revision date: 25/8/2020
Version: 1
Language: en-GB,IE
Date of print: 30/9/2020
Page: 10 of 19
General protection and hygiene measures:
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No
smoking.
Take off contaminated clothing and wash it before reuse. Contaminated work clothing
should not be allowed out of the workplace.
When using do not eat or drink. Do not get in eyes, on skin, or on clothing. Avoid
breathing vapours/spray.
Wash hands before breaks and after work. When handling large quantities, supply
emergency spray.
Environmental exposure controls
Do not allow to enter into ground-water, surface water or drains.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Appearance:
Physical state at 20 °C and 101.3 kPa: liquid
Form: Aerosol
Colour: silver
Odour:
characteristic
Odour threshold:
No data available
pH:
No data available
Melting point/freezing point:
not determined
Initial boiling point and boiling range:
not applicable
Flash point/flash point range:
not applicable
Evaporation rate:
No data available
Flammability:
Extremely flammable aerosol.
Explosion limits:
LEL (Lower Explosion Limit): 1.50 Vol-% (propellant)
UEL (Upper Explosive Limit): 26.20 Vol-% (Dimethyl ether)
Vapour pressure:
at 20 °C: <= 70 hPa
Vapour density:
No data available
Density:
at 20 °C: 0.884 g/mL (liquid)
Water solubility:
not or slightly miscible
Partition coefficient: n-octanol/water:
No data available
Auto-ignition temperature:
No data available
Decomposition temperature:
No data available
Viscosity, kinematic:
No data available
Explosive properties:
Product is not explosive. Potentially explosive vapour/air mixtures may form.
Oxidizing characteristics:
No data available
9.2 Other information
Solvent content:
88 %
printed by Conrad Electronic with Qualisys SUMDAT