AT850D Hot Air Station USER’S Manual SHENZHEN ATTEN TECHNOLOGY CO., LTD.
Content Content..............................................................................................................1 Copyright ...........................................................................................................2 Symbols and Conventions .................................................................................2 Assumption for User .........................................................................................2 Safety.........................................
Copyright The design of this product (including software) and its accessories is under tutelage of laws. Any action to violate relevant right of our product will be penalized through law. Please consciously observe relevant local laws in the use of this product. Symbols and Conventions Thank you for purchasing this soldering station product. Please read this manual carefully and pay attention to warnings and precautions mentioned herein before using this product.
Disclaimer ● ● For physical injuries and possessions loss caused by those reasons which are not related to product quality such as operating without following manual guide, natural disasters or force majeure, we take no responsibility for that. Under the supervision of Shenzhen ATTEN Technology Co., Ltd, this manual has been compiled and published which covered the latest product description and specification. The content of this manual is subject to change without notice.
Model Air flow Net weight AT850D 23L /min(Max) 4.0 Kg First Glance PM3*6 Installed on left side PM3*6 Installed on right side Operational Guide 1 2 3 4 Installation 1.1 User should install handle stand of hot air gun supporting stand according to user's personal operation habits, on left side or on right side as schematic representation shows, for your first operation on this product. Then check it favorable for you after you put handle on handle stand. Connection 2.
4.3 Temperature unit switching: Holding down "SET" and turning on switch will switch temperature scale between Fahrenheit and Celsius. 4.4 Standby time: a) Press and hold the "SET" button, then screen displays "- - -", adjust air volume knob to set standby time which range from 20s to 600s. Release holding and stand time settings will be stored. b) The device will make a beep and LED numbers start to blink when time remaining is less than 10s.
5 Replace with new heating element 5.1 Please take care! Do not rub wire of heating element. Plug a new heating element and reconnect wires with attention to circuit polarity (red to red, yellow to yellow).Assemble handle in reversed disassembling order. Service Contact Service Department TEL: 86-755-61618282 Certificate of Product Warranty This product warranty period cover 12 months from the day this product purchased.
SHENZHEN ATTEN TECHNOLOGY CO., LTD. ●Soldering Iron ●Soldering Station ●Hot Air Rework Station ●Multi-function Rework System ●BGA Rework System ●Regulated DC Power Supply ●Switching DC Power Supply ●Programmable Power Supply ●RF Microwave Instruments ●RF Microwave Components ● Attenuator ●Amplifier ●Coaxial Load SHENZHEN ATTEN TECHNOLOGY CO., LTD. Add: Buiding A29, Tanglang Industrial Zone, Xili, Nanshan District, Shenzhen 518055, P.R.
