Instruction Manual

Rubbercap Glass tube Cottonlter

Spring Metal plate

• Replacethespringintheglasstube.

• Place the glass tube back into the desoldering gun.

• Press the lock in the direction of the glass tube until the release lever jumps to the lower position.

c) Cleaning the desoldering gun

 If there is a signicant reduction in suction power, interrupt the process and immediately clean the

desoldering gun.

• Directly after desoldering, press the trigger 3 to 5 times to remove residual solder from the tip and the inner tube.

• Use the cleaning tool to clean the inside of the tip and the inner tube of the heating element.

d) Replacing the lter

Replacethecottonlterdiscsonthesuctionopeningofthestationandintheglasstubeassoonastheyhave

hardened.