Instruction Manual

22
8. Operation
a) Installation site and connection
Protect heat-sensitive surfaces with a suitable cover.
 Neverplacetheproductonvaluablefurnituresurfaces,oorsorcarpets.
 Maintainasufcientdistancefromcombustibleorammableobjects(e.g.curtains).
• Placetheproductonahorizontal,stable,sufcientlylargesurface.
• Assemble the stand. Insert the metal tongue of the holder into the appropriate slot of the base. The holder must be
located above the sponge holder.
Risk of re!
If you insert the holder incorrectly so that it extends over the edge of the base, the holder may tip over when
you insert the desoldering gun.
• Connectthemainscableofthedesolderinggunwiththeappropriatesocketonthestation.Theplugtsonlyinone
direction. Do not use any force.
• Connect the suction hose with the appropriateopening on the station. Turnthecapclockwise to secure the
connection.
• Place the desoldering gun in the stand.
• Connectthemainsplugtoastandardmainssocket.
b) Switching on and off
• Switchonthestationviathemainsswitchontherear(switchpositionI = on). The product immediately begins
heating up after it switches on. The display shows the current temperature of the desoldering gun.
If the message EEE appears on display, turn off the station. Disconnect the desoldering gun and reconnect
it with the station. Make sure that the plug is connected correctly and that the union nut is hand-tight. Turn
the product back on. If the message EEE persists, the desoldering gun is defective and must be replaced.
• Switchofftheproductafteruse(switchpositionO = off).
c) Setting the temperature
• Press the + button to increase the temperature by 1 degree.
Press the – button to reduce the temperature by 1 degree.
Press and hold the button to fast forward.
• With the °C/°Fbutton,youcanswitchdisplaybetweenCelsiusandFahrenheit.