User manual

32
Fault Possible cause Solution
The hoist gets progressively louder. Thepartsarenotsufciently
lubricated.
The gears and bearings are worn
out.
The hoist was not installed
correctly, or the parts are dented.
Oil the product according to the
maintenanceinstructions.Replace
thegearsandbearings.Checkthat
the hoist was installed correctly.
Motor overvoltage. The earth is faulty or not grounded.
Internal wires are touching metal
parts of the housing.
Checkthegroundwiresandensure
that they are connected properly.
Checkallinternalwireconnections
and ensure that they are connected
properly.
The stop/limit switches do not work. One of the switches (13/14) is
defective.
The stop/limit switch (13/14) is
obstructed.
Turn off the hoist.
Checkthestop/limitswitchand
repair/change it if necessary.
15. Disposal
Electronic devices are recyclable waste and must not be placed in household waste. Always dispose of the
product according to the relevant statutory regulations.
Youthusfulllyourstatutoryobligationsandcontributetotheprotectionoftheenvironment.
16. Technical data
a) Item no. 1550315
Operating voltage .............................................230V/AC,50Hz
Operating current ..............................................2.18 A
Power consumption ..........................................Max. 500 W
Protection rating ...............................................IP54
Nominal load .....................................................125/250 kg (without/with pulley)
Lifting height .....................................................12/6 m (without/with pulley)
Ratedspeed .....................................................8/4 m per min