Instructions

• If dowels are required, insert the dowels into the holes and then insert suitably sized screws. If dowels are not

required, insert the screws directly into the wooden or metal surface.

• Always use washers that cover the elongated holes on the base plate and spread the force from the screws over

asufcientlylargearea.

• The screws and dowels required for mounting are not included with the product and must be purchased separately.

• When mounting the product to mineral surfaces, use screws with a diameter of at least 10 mm and a length of

at least 60 mm. For metal surfaces (normally structural steel), use screws with a length of approximately 25 mm.

When placing screws into clearance holes, ensure that the screw is long enough to allow the nut to be fully screwed

onto the thread. If the nut is only screwed to a few threads it may become loose.

b) Connecting the compressed air supply

• Onceyouhavemountedtheproduct,connectthecompressedairinlettoasourceofcompressedairwitha1/4"

connector.

• Ensure that there is a shut-off valve so that the supply of compressed air can be turned off when you are not using

the product, or when you carry out maintenance work.

10. Operation

a) Unrolling the hose

• Unroll the hose to the desired length and then allow it to move backwards slightly until it clicks into place.

• Ifitdoesnotclickintoplace,unrollthehoseabitmoreandtryagain.Repeatthisstepuntilthehoseisinthedesired

position.

Do not continue to pull on the hose when it has been fully unrolled, otherwise the hose may come off the

hose drum and cause injuries.

b) Rolling the hose

• Pull the hose slightly until it releases. Slowly guide the hose onto the hose drum until it is fully rolled.

Do not let go of the hose when it is rolling onto the hose drum, otherwise it may spring back quickly and

cause injuries or damage to property. Always hold the hose tightly and guide it carefully onto the hose drum.

c) Product settings

Always disconnect the product from the compressed air supply before carrying out any

maintenance or repair work.