User manual

19
11. Maintenance
• Thisproductislow-maintenanceandonlycontainsafewpartsthatrequiremaintenance.Repairworkmustbedone
by a specialist technician.
• Keep the hose clean to ensure that the product works properly.
• Removeanydirtthataccumulatesontheconnectingparts.Regularlycheckthevalvestoensurethatthereareno
loose connections, leaks, cracks or other signs of damage.
• Checkthemounting componentsfromtime totimeto ensurethatthere arenolooseconnectionsorsignsof
damage.
12. Troubleshooting
Always disconnect the product from the compressed air supply before carrying out any maintenance or
repair work.
Fault Possible cause Solution
The hose does not wind
back onto the drum fully.
• The hose was rolled too quickly.
• The hose was not rolled evenly
and became tangled.
• The replacement hose is too
heavy.
• The hose stop ring (6) was
adjusted.
• Rollthehoseslowly.
• Rosethehoseevenly(ifnecessary,open
the cover and guide the hose with your
hand).
• Use a replacement hose with a suitable
weight.
• Move the hose stop ring to the correct
position.
The hose doesn't click
into place.
• The hose reel was not installed
correctly.
• The hose was released too
quickly.
• See section 9 ("Installation") for details.
• Hold the hose in your hand and slowly
guide it back onto the hose drum.
Air escapes from an
unsealed part.
• The hose is damaged.
• The hose clamp is not properly
secured.
• Replacethehose.
• Replacethehoseclamporsecureitin
place.