User manual
OPERATING INSTRUCTIONS
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright
2015
by Conrad Electronic SE.
V1_0515_02-ETS-Mkd
c) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the device.
• Maintenance, modications and repairs are to be performed exclusively by an expert or at a
qualied shop.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
Operation
a) Inserting/replacing batteries
• Press the yellow triangle and slide the battery compartment lid downwards.
• Insert 3 AAA batteries and heed correct polarity. Heed correct polarity as indicated in the battery
compartment.
• Close the battery compartment.
Replace the batteries once the luminous power of the LED starts to reduce signicantly.
b) Illumination
Switch the illumination on or off using the slide switch on the side.
Maintenance and cleaning
• The product is maintenance-free except for potential battery replacement and occasional cleaning.
• Do not use any abrasive or chemical cleaners.
• Never submerge the product in water to clean it.
• When cleaning, do not apply too much force to the lens or housing in order to avoid scratches.
• Use a lens or eyeglasses cleaning towel for cleaning. Alternatively, use a dry, clean, soft and lint-free cloth
or a dust brush. If necessary, you can moisten the cloth with a little lukewarm water.
• If cleaning the lens with a cleaning agent, make sure not to directly apply the cleaner to the lens. Always
apply the cleaning agent directly to the cloth rst.
• Use a dry, clean, soft and lint-free cloth for cleaning the housing. To remove tougher stains, slightly
dampen the cloth with lukewarm water. You may use a little soap or a mild cleaning agent.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from the product.
b) (Rechargeable) batteries
You as the end user are required by law (Battery Ordinance) to return all used batteries/rechargeable
batteries. Disposing of them in the household waste is prohibited.
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that disposal
in the domestic waste is forbidden. The designations for the heavy metals involved are: Cd =
Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable) batteries, e.g. below the trash
icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our stores
or wherever (rechargeable) batteries are sold.
You thus full your statutory obligations and contribute to the protection of the environment.
Technical data
Power supply .......................... 3 x AAA battery (not included)
Current consumption .............. max. 25 mA
Magnication factor ................ 15x (item no. 1303080)
10x (item no. 1303081)
Focal length ............................ 14 – 16 mm (item no. 1303080)
20 – 23 mm (item no. 1303081)
Light colour ............................. Cold-white
Operating conditions ............... +5 to +40 ºC, <80 % RH
Storage conditions .................. +5 to +40 ºC, <80 % RH
Dimensions (W x H x D) ......... 105 x 38.5 x 33.7 mm (item no. 1303080)
105 x 38.5 x 25.5 mm (item no. 1303081)
Weight .................................... 48 g (item no. 1303080)
40 g (item no. 1303081)
Illuminated LED magnier
Version
05/15
Item no.
1303080
(15x)
Item no.
1303081
(10x)
Intended use
The product is intended for creating an enlarged view of objects. There is an LED located below the lens
intended for illuminating the viewed objects. The product is operated by 3 AAA batteries (not included).
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the
product for purposes other than those described above, the product may be damaged. In addition, improper
use can cause hazards such as short circuiting, re, electric shock etc. Read the instructions carefully and
keep them. Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and
product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Illuminated LED magnier
• Storage case
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) Persons / Product
• Never direct the magnier at the sun or other strong light sources or at anything nearby those.
This poses a risk of loss of eyesight!
• In case of improper handling the magnier can act as a burning lens. This poses a re hazard!
Do not leave the magnier exposed to sunlight.
• Do not use the magnier when moving, as you might overlook obstacles and trip over them.
• Do not touch the lens with your ngers (especially nger nails) or any sharp/pointed objects.
• Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become dangerous
playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, ammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from
any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage
the product.
b) (Rechargeable) batteries
• Correct polarity must be observed while inserting the (rechargeable) batteries.
• (Rechargeable) batteries should be removed from the device if it is not used for a long period
of time to avoid damage through leaking. Leaking or damaged (rechargeable) batteries might
cause acid burns when in contact with skin, therefore use suitable protective gloves to handle
corrupted (rechargeable) batteries.
• (Rechargeable) batteries must be kept out of reach of children. Do not leave (rechargeable)
batteries lying around, as there is risk, that children or pets swallow them.
• All (rechargeable) batteries should be replaced at the same time. Mixing old and new
(rechargeable) batteries in the device can lead to (rechargeable) battery leakage and device
damage.
• (Rechargeable) batteries must not be dismantled, short-circuited or thrown into re. Never
recharge non-rechargeable batteries. There is a risk of explosion!