Safety data sheet

TOOLCRAFT Epoxy Resin L
Safety Data Sheet
Product code: 886593
Print date: 26.09.2014 Page 3 of 7
Conrad Electronic SE
according to Regulation (EC) No 1907/2006
Fire residue and contaminated firefighting water must be disposed of in accordance with government
regulations.
Additional information
SECTION 6: Accidental release measures
Wear personal protection equipment. Keep unprotected persons at a safe distance.
6.1. Personal precautions, protective equipment and emergency procedures
Do not allow to enter into surface water or drains. Do not allow to enter the soil or subsoil.
6.2. Environmental precautions
Absorb with liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents).
Treat the recovered material as prescribed in the section on waste disposal.
6.3. Methods and material for containment and cleaning up
Carefully cleaning scene of an accident.
6.4. Reference to other sections
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Keep receptacles tightly sealed. Provide adequate room ventilation, if necessary with vapour
extraction at the workplace.
Advice on safe handling
7.2. Conditions for safe storage, including any incompatibilities
Keep only in the original container. Provide for retaining containers, eg. floor pan without outflow.
Requirements for storage rooms and vessels
Store separately from foodstuffs.
Advice on storage compatibility
Keep receptacles tightly sealed.
Further information on storage conditions
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
8.2. Exposure controls
Remove contaminated, saturated clothing immediately. Protect skin by using skin protective cream.
After work, wash hands and face. When using do not eat or drink.
Protective and hygiene measures
Dichtschließende Schutzbrille
Eye/face protection
Nur Chemikalien-Schutzhandschuhe mit einer CE-Kennzeichnung der Kategorie III verwenden. Zur
Minimierung der Nässe im Handschuh durch Schweißbildung ist ein Wechseln der Handschuhe
während einer Schicht erforderlich. Vor jeder erneuten Verwendung des Handschuhs ist die Dichtheit
zu prüfen.
Nitrilkautschuk oder Fluourkautschuk oder Handschuhe aus PVC. Empfohlene Materialstärke >= 0,5
mm
Hand protection
Arbeitschutzkleidung
Skin protection
Bei unzureichender Belüftung Atemschutz
Respiratory protection
Revision No: 1,01 Revision date: 26.09.2014 GB - EN