Fire Pit Table Owner’s Instruction manual
Warnings DANGER CARBON MONOXIDE HAZARD ● This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you. ● For outdoor use only. ● Never use in the unventilated or enclosed areas. IF YOU SMELL GAS: ● Shut off gas to the appliance. ● Extinguish any open flame. ● If odor continues, keep away from the appliance and immediately call your gas supplier or fire department for help. WARNING ● If the propane gas tank is leaking gas, you may hear, see, or smell a hiss.
Warnings WARNING ● The installation of this unit must adhere to local codes or either the National Fuel Gas Code, ANSI Z223. 1/NFPA54, OR CAN/CGA- B149.1, National Gas and Propane Installation Code. ● This unit is to be used with propane gas only! (sold separately), is not intended for natural gas. ● Do not use any solid fuel or charcoal for this unit. ● Do not use any more than 1/4in depth lava rocks/ pumice stones/ Lava Glass above the burner holes. Doing so will suffocate the flame.
Warnings WARNING ● DO NOT add water into the unit. ● DO NOT disconnect any part while the unit is in use. ● DO NOT operate on a boat or vehicle. ● DO NOT set the Protective Cover over the unit until the Fire Table / Column is turned off and completely cooled down (where applicable). ● Check for leaks after not using the unit for long periods of time. WARNING ● All installation and repair should be done by a Qualified Service Technician. This unit should be inspected annually and cleaned regularly.
Warnings WARNING ● Do not operate unit until all parts are fully assembled. ● Do not attempt to move it while in use. ● This unit is not intended for cooking. ● Young children should be carefully supervised when they are in the area of the appliance. ● Keep away from the unit for the first 20 minutes after igniting for the first time, as lava rock /pumice stones could pop out and cause injury. ● Do not set the protective cover over the unit until it is turned off and completely cooled down.
Parts Diagram Tabulated here below are the description to all parts as shown in above Picture .
G F H D C B Metal lid 1 AA Battery 1 Panel C 2 Panel D 1 Protective Cover 1 F Panel F 1 G Table Top 1 Adjust foot 4 Hardware S00 Bolt (M6*35MM) S00 Bolt (M6*16MM) 8 W002 M6 Washer 12 T001 Hex Bolt Driver 1
Assembly Instructions T001 S003 W002 1 Attach panel (F) and (D) to the table top (G) 003 2 F D G F 2 C Attach panel (C) 2pcs with Panel (D) and Panel (F) together by using 8pcs Bolts (S003) and 8pcs M6 washer(W002) with B Hex Bolt Driver T(001). Please do not fully tighten.
Assembly Instructions Step 3: Attach adjust foot (H) to the bottom of fire pit using 8pcs of Bolts (S001) with Hex Bolt Driver (T001). And tighten the Bolts. Step 4: Put the metal lid on the table top of fire pit. Then tighten all the bolts.
User's Instructions Step : 1. Check that the Contro Knob for the gas supply system is turned to the "OFF'' position before starting any assembly. 2. Place a 20 lb Propane Gas Tank (not included) into a secure position. Step : Turn the Cylinder Valve on the tank in a clockwise direction to TURN OFF SUPPLEY of the LP Gas supply-Attach the preassembled Regulator (19) from the Fire Table to the Cylinder Valve (21) by turning the Black Regulator Coupling Nut clockwise.
User's Instructions Step 7: R B B B S Step 8: DO NOT PLACE GLASS ROCKS ON THE PROTECTIVE GUARD. KEEP GUARD CLEAR.
SAFETY INFORMATION Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied directly by us. Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance. NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools. Standard 20 lb.
Operation FOR YOUR SAFETY, READ BEFORE LIGHTING • Before performing a leak test, make sure that no sparks can occur and you are in a spacious outdoor area. • Connect the propane gas tank to the regulator and turn the valve on the unit to the “off” position. • Brush a soap and water mixture on all connections. • Make sure the igniter battery has been installed properly. The igniter will not operate otherwise. • Before operating, smell around the appliance and next to the ground for gas odors.
Operation S 3. 10-15 Keep holding To Extinguish 1. Close the cylinder valve on the propane gas tank if you don’t intend to use it for a long time. 2. Turn control knob clockwise to the “HIGH” position; let the knob pop up and continue turning the control knob to the “OFF” position.
Maintenance & Storage To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance activities on a regular basis: • Before performing any maintenance always disconnect propane gas tank. • Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents. • Keep the heating item free and clear from combustible materials. • Visually inspect burner for obstructions and keep tank enclosure free and clear from debris.
Trouble Shooting PROBLEM Burner will not light using igniter Burner will not light with match The fire table emits a lot of black smoke when in use Sudden drop in gas flow, or a reduced flame height CAUSE Electrode and burners are wet SOLUTION Wipe dry with cloth. Igniter battery is dead or backwards Check that the battery is inserted correctly in the igniter or replace the battery. Make sure the plastic wrap on the battery has been removed.
Trouble Shooting Problem: Burner JUST LIGHT UP FOR SECOND AND WILL AUTOMATICALLY TURN OFF PILOT GUARD 1 2. 3 . THERMOCOUPLE IGNITION PIN 4 . IGNITION PIN THERMOCOUPLE 1. The thermocouple will be under the Pilot Guard on the top of the unit. Please remove the Pilot guard by unscrewing it from the metal bowl with a screw driver. 2. Once the Pilot Guard has been removed, you will have two components exposed; the copper one is your thermocouple. Please unscrew the nut holding the thermocouple in place.
