Use And Care Manual

12
Fig. 3
INSTALLING IMPACT SOCKETS
WARNING: Use only impact sockets
and accessories that are designed for use
with an impact wrench. Do not use chrome
plated sockets and accessories. Chrome plated
sockets and accessories are designed for hand
use only and MUST NOT be used with an
impact wrench. They may shatter and possibly
cause serious injury.
WARNING: Always remove the battery
from the tool before changing any sockets or
accessories. You may injure your hand if the
tool is started accidentally.
To install a socket, press the square portion of
the socket (1) onto the square drive (2) of the
impact wrench (Fig. 3).
NOTE: Slide the socket fully onto the square
drive so the socket retainer (3) will hold the
socket firmly in place.
FORWARD/REVERSE SWITCH
This impact wrench is equipped with a
forward/reverse switch (1) (Fig. 4).
1. To operate the impact wrench in the
reverse direction, press the
forward/reverse switch to the RIGHT. This
direction of rotation will loosen the
fastener.
2. To operate the impact wrench in the
forward direction, press the
forward/reverse switch to the LEFT. This
direction of rotation will tighten the
fastener.
NOTE: Never press the forward/reverse
switch while the impact wrench it turned
ON. Damage to the tool will result.
VARIABLE SPEED TRIGGER SWITCH
This impact wrench is equipped with a variable
speed ON/OFF trigger switch.
1. To start the impact wrench, gently squeeze
the trigger switch (2) (Fig. 5).
NOTE: The impact wrench will turn at its
slowest speed when the trigger switch is
depressed slightly. The impact wrench will
turn at its fastest speed when the trigger
switch is fully depressed.
2. To stop the impact wrench, release the
trigger switch.
NOTE: Never allow your hand to cover the
air vents of the impact wrench. Running the
tool at slow speeds will cause it to heat up.
If the tool gets warm while running at slow
speeds, stop and allow it to cool.
ASSEMBLY AND OPERATING
!
!
Fig. 4
Fig. 5