Owners manual

1. Center the cover on the front end of
the bed and the side rails, and begin
to tighten the clamps until they are
snug. Do not tighten completely.
Repeat on the opposite side of the
truck.
2. Unclip the snap clips located in the
front of the cover allowing the cover
to unfold. The cover has retaining
straps with quick-release buckles to
keep it from being damaged when
bulk hauling or when it is not on
the vehicle. Failure to install the
front slide-clamps properly will
result in cover fly-off which is
not covered by Manufacturer’s
Warranty.
TONNO FOLD | HARD FOLD
INSTALLATION INSTRUCTIONS
Hardware:
Everything comes pre-assembled. No hardware or tools are needed for this installation. The Front & Rear Clamps are the
main moving compenents. Please be sure you have 2 of each attached to the cover before you begin your installation.
Thumb Nut
Clamp
Adjust front slide-clamp
to proper height.
Slide front clamp holder
under truck bed rail.
Rotate thumb nut to tighten
clamp enough (not too tight).
Front Slide-Clamp Mechanism
Rear Slide EZ-Clamp Mechanism
Tighten
“Counter Clockwise”
Loosen
“Clockwise”
page 2
EZ Cam Clamp
Handle Lever