Data Sheet

such that 20 cm may be maintained between the antenna and users. The final end product
The final end product must be labeled in a visible area with the following " Contains TX FCC
This module is intended for OEM integrator. The OEM integrator is still responsible for the
For IC:
This device complies with RSS247 of Industry Canada. Cet appareil se conforme à
RSS247 de Canada d'Industrie. This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the
device. appareils radio exempts de licence. Son fonctionnement est sujet aux deux
conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
prejudiciable, et (2) ce dispositif doit accepter tout brouillage recu, y compris un
brouillage susceptible de provoquer un fonctionnement indesirable.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme a la norme NMB-003 du
Canada.
The device should be installed and operated with a minimum distance of 20cm between the
radiator and your body.
L'appareil doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateu
et votre corps.
FCC/IC compliance requirement of the end product which integrates this module.
LABEL OF THE END PRODUCT:
ID: ZVA14 ".
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed
must be labeled in a visible area with the following: “Contains TX IC : 9976A-14”.
Ce module est destiné à l'intégrateur OEM. L'intégrateur OEM est toujours responsable
des exigences de conformité FCC / IC du produit final intégrant ce module.
ETIQUETTE DU PRODUIT FINAL:
Le produit final doit être clairement visible dans la zone "Contient le TX FCC ID: ZVA14".
étiquetage du produit final
Ce module émetteur est uniquement autorisé à être utilisé dans un appareil où l’
antenne peut être installée de manière à ce que 20 cm puissent être maintenus entre
l’antenne et les utilisateurs. Le produit final doit être étiqueté dans une zone visible
avec les informations suivantes: “Contient le TX IC: 9976A-14”.