FCC INFORMATION: This equipment has been tested and no found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not used these instructions, may cause harmful interference to radio communications.
Battery Recharge The unit has a built in Li‐ion rechargeable battery, recharge it before use as follow: Connect the Mirco USB plug from the USB Connection Cable to the Micro USB Port on the rear of unit. Connect the full size USB plug to the USB port on a computer or any USB charger having DC 5V output. (During charging, the Red Indicator will illuminate. When finished, it will turned off). Notes: Your battery will last longer if you following these simple guidelines for charging and storing. A.
OPERATON: General operation: 1. 2. 3. 4. 5. Press and hold the Button approximate 0.5 second to turn it on. Button repeatedly until the desired mode hearing from speaker as Press the below: Blue tooth ready for connection Blue tooth connected Radio Line in ( =Aux in ) USB Memory Card Press and hold the or Button to adjust volume level. In BT; TF (SD) Card and USB Device playback mode: Press and release the or Button repeatedly to skip tracks.
Radio: 1. Power on the unit as previous procedures. Press the Button repeatedly unit “Radio” hear from the speaker. 2. Press the Button to searching and stored the available FM stations. During searching, the Blue Indicator will blink. When finished searching, the Blue Indicator will stop blinking. 3. Press and release the or Button repeatedly t plays the previous/next available FM station. FM Antenna: The FM Antenna is built in the unit.
Before replacing USB Device or TF (Micro SD) Card, make sure the unit has been powered off. When inserting the USB Device or TF(Micro SD) Card, make sure the direction you selected is correct. Never insert violently to avoid damaging the USB Device or the unit. If it doesn’t work, please check if the direction is correct. You also need to download the desired music in MP3 format into the USB Device and/or TF (SD) Card before installing into the unit.
Troubleshoothing: Can’t power on No sound or sound weak Sound distortion Built in battery consumed Volume of the unit was set to minimum position Volume of paired/connected device in low level Volume level too high Volume level of the connected/paired device too high EQ of the connected/paired device was set to super bass BT not functioning The USB Device/Micro SD Card can’t be play Recharge the battery Increase the volume by press and hold the Button Rise the volume level of the connected/paired devic
7
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
