User's Manual

Page 7
Batteries Installation ( Remote Control )
-First time use:
Remove and discard the insulation film as the figure on right.
-Replacing battery for the remote control:
1. Push and slide out the battery tray as the figure below.
2. Replace the battery by a new button cell with the polarity ”+” face up as the figure below and the rear of remote control.
3. Close the battery up
Batterie Precautions:
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery compartment. A reversed battery may cause
damage to the device
3. Do not mix different types of batteries together or old batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long period of time, remove the batteries to prevent damage
or injury from possible battery leakage.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.(Follow battery manufacture’ s instructions.
6. The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
7. Clean the battery contacts and also those of the device prior to battery installation.
Effective Distance of Remote Transmitter
NOTES:
1. When there is an obstacle between the unit and the transmitter, the
transmitter may not operate.
2. When direct sunlight, an incandescent lamp, fluorescent lamp or any
other strong light shines on the REMOTE SENSOR of the unit, the remote
operation maybe unstable.