User manual

11
First, check that the battery is charged. To charge the battery, connect your START to the car charger.
It can take 3 - 5 hours to fully charge the battery depending on the type of device.
Important: Do not charge your device using your vehicle's own USB port because it is not powerful
enough.
If this does not solve the problem, you can perform a reset. To do this, press and hold the On/Off
button until your START begins to restart.
Charging your device
The battery in your TomTom START charges when you connect it to your TomTom vehicle charger, to
your computer or to a USB Home Charger.
Important: Do not charge your device using your vehicle's own USB port because it is not powerful
enough.
You are warned when the battery level is low or critical. You lose your connection to some TomTom
services when the battery level is low or critical. When the battery is empty, your START goes into
sleep mode.
Important: On device models START 42/52, START 40/50/60, and GO 51/61, the screen intentionally
dims when you connect your device to your computer. The screen also dims if you use a non-TomTom
charger that does not provide enough power when charging.
Note: Use ONLY the USB cable supplied with your START. Other USB cables may not work.
Finding the memory card slot
The memory card slot is under the mount.
To insert a memory card, release the mount from the START using the thumb indent. Insert the
memory card into the slot. Clip the mount back onto the device until you hear it click.
Caring for your START
It is important to take care of your device:
 Do not open the casing of your device under any circumstances. Doing so may be dangerous and
will invalidate the warranty.
 Wipe or dry the screen of your device using a soft cloth. Do not use any liquid cleaners.