Operation Manual

Set as
departure
Sets the location as the departure location for the next route to be
planned - this is only relevant for routes planned using the "plan" button
(8), since normal turn-by-turn navigation will always depart from your
current GPS position.
Set as
destination
Sets the location as the destination for the next route that is planned.
Add to
favourites...
Allows you to turn the location into a "favourite" location (see chapter 3).
View favourite
Allows you to view the details of an existing favourite.
Add as point of
interest
Allows you to turn the location into a Point of interest. You will need to
specify the name and category of the Point of interest. Note that you can
only add locations to new categories that you have defined yourself. The
very first time, you must specify the name of a new category.
Note: you can not convert built-in Points of interest to your own Point of interest categories.
Nearby points
of interest...
Allows you to find points of interest near the location.
Edit point of
interest
Allows you to edit the name and category of a Point of interest that you
added previously.
Delete point of
interest
Allows you to delete a Point of interest that you added previously.
Center on
screen
Redraws the map with the location in the exact center.
Reset GPS for
this location
Informs your GPS receiver that you are roughly near the tapped location.
If you have not used your GPS for more than a week, or have travelled
more than 200 miles/300 kilometres since you last used it, this option
can seriously reduce the time it takes your GPS to find satellites.
Finding locations
The FIND button (9) pops up a menu that allows you to find a specific location, and then do
something with it such as displaying it on the map, or setting it as your destination. You can find
different types of locations: