User's Manual

Table Of Contents
8
Installing in your car
Use the supplied mount to install your TomTom GO PROFESSIONAL in your vehicle. Read the
instructions about positioning your device before you install your GO PROFESSIONAL.
To install your GO PROFESSIONAL, do the following:
1. Connect the supplied USB cable to the mount. If the mount is integrated into your GO
PROFESSIONAL, connect the USB cable to the device.
Note: Use ONLY the USB cable supplied with your GO PROFESSIONAL. Other USB cables
may not work.
2. Connect the USB cable to the USB car charger and plug this into the power supply on your
dashboard.
3. Choose the best smooth location, on your windscreen or side window, to mount your TomTom GO
PROFESSIONAL.
Tip: If the mount is integrated into your GO PROFESSIONAL, you can easily change the rotation
of your device. Push the button on the back of the device to release the mount, then slide the
mount out. Insert it back into the other side of the device.
4. Make sure that both the suction cup on the mount and your windscreen are clean and dry.
5. Press the suction cup of the mount firmly against your windscreen.
6. Turn the rubber grip near the base of the mount in a clockwise direction until you feel it lock.
7. If your mount is not integrated into your GO PROFESSIONAL, place your GO PROFESSIONAL in
the mount, making sure that it clicks into place.
Dashboard adhesive disks are available as part of a range of accessories for your GO
PROFESSIONAL. For more information, go to tomtom.com/accessories.
Positioning the device
Be careful where you install your GO PROFESSIONAL. The GO PROFESSIONAL shouldn't block or
interfere with any of the following:
Your view of the road.
The controls in your vehicle.
Your rear-view mirrors.
The airbags.
You should be able to reach your GO PROFESSIONAL easily without leaning or stretching. In a car,
you can attach your GO PROFESSIONAL to the windscreen or side window or you can use a
Dashboard Mount Disk to attach the mount to your dashboard.
Switching on and off
Switching your device on
Press the On/Off button until your device starts. If the device was off you see the map view. If your
device was sleeping you see the last screen you were looking at.
Get going