Operation Manual

Voice command and control5.

Voice command and control

Instead of tapping the screen to control your TomTom GO, you can now give

instructions to your GO using your voice.

For example, to increase the volume on your GO, you can say, "Increase vol-

ume."

Important: To use command and control, you must have a computer voice

installed on your TomTom GO. You can install computer voices using

TomTom HOME.

To view the list of available commands, tap Command and control in the Pref-

erences menu and then tap What can I say?

Using voice command and control

Note: You must select a computer voice in order to use voice command and

control. To select a computer voice, tap Voices in the Preferences menu, then

tap Change voice. Select a computer voice.

In this example, you will use voice command and control to plan a journey to

your Home address.

1. Tap the microphone button in the Driving View.

Note: To add or remove this button from the Driving View, tap Com-

mand and control in the Preferences menu, then tap Enable command and

control or Disable command and control.

The microphone monitor is shown in colour, unless command and control

is busy with another task.

2. When you hear a beep, say, "Navigate to Home."

When you speak, the microphone monitor shows if you are talking too

loudly or quietly:

A green bar means your voice is at the right level for your device

to hear your commands.

A red bar means your voice is too loud.

A grey bar means your voice is too quiet.

For some phrases, your device repeats the command, then asks you if the

command has been correctly recognised.