User guide

Minnesota State Legislature Statutes Section 169.71, subdivision 1, section 2 provides that "A

person shall not drive or operate with any objects suspended between the driver and the wind-

shield other than sun visors and rearview mirrors and electronic toll collection devices."

Note: this Minnesota Stature applies to anyone driving in Minnesota, not just Minnesota residents.

TomTom Inc. bears no responsibility for any fines, penalties or damage that may be incurred by

disregarding this notice. While driving in any state with windshield mounting restrictions,

TomTom recommends the use of the supplied Adhesive Mounting Disk or its Alternative Mount-

ing Kit, which includes multiple options for mounting TomTom devices on the dashboard and the

air vents. See tomtom.com for more information about these mounting options.

FCC information for the user

THE DEVICE COMPLIES WITH PART 15 OF THE FCC RULES

Federal Communications Commission (FCC) Statement

Radio and television interference

This equipment radiates radio frequency energy and if not used properly - that is, in strict accord-

ance with the instructions in this manual - may cause interference to radio communications and

television reception.

This device has been tested and found to comply with the limits for a Class B digital device, pur-

suant to part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful inter-

ference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is con-

nected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.