Installation Guide

Tommy Docks Bracket Installation (continued)
D-Bracket (3-way inside corner)
For connecting three dock sections
1. Position D-Bracket (refer to dock layout)
making sure that dock’s frame is seated
completely in the saddle of the D-Bracket.
Header frame must not protrude past the angle
plate or the next dock section will hit.
2. Drill one (1) 1/2” diameter hole.
Note: Do not attempt to drill pin assembly hole
in next dock section until your dock is completely
installed on water and leveled.
3. Install one (1) 1/2”-13 x 2-1/4” bolt, washer
and nut. The nut is positioned on the inside of
the dock’s frame.
1/2” Dia. Pin
1/2” Flat Washer
1/2” NC Hex Nut
1/2” NC Hex Head
Cap Screw x 2-1/2”
Outside
Dock
Dock
Frame
Dock Frame
Dock Frame
Dock
Frame
Inside
Dock
Inside
Dock
Inside
Dock
D-Bracket
(3-way inside corner)
D-Bracket
(3-way inside corner)