Instructions / Assembly

8
Make sure all of the connections are fitted tightly and tighten all of the screws you have installed so far on the
top side of the frame. Use the Hex Bit to fully tighten the Stainless Steel Truss Head Screw while holding in
place the Stainless Steel Nylon Locknut with a 3/8” Box End Wrench.
This illustration shows the remaining connection of the Crossmember into
the Side Rail that remains unattached. The purpose for this is to allow room
to slide individual boards into place in the forward section of the frame. (If you
are planning on making removable drop in deck panels for the frame you can
disregard this step and install the screws and tighten this connection to the
Side Rail.)
Stainless Steel
Truss Head Screw
Stainless Steel
Nylon Locknut
3/8” Box
End Wrench
Hex Bit
NOTE: When assembling the frame
components, if you encounter holes that do not
line up exactly, it is acceptable to use a drill to
ream out the holes slightly for the fasteners to fit
appropriately.