Full Product Manual

A
B
1
A
B
2
3/4” (#12)
Fastener-A
(full threaded)
(Qty 22)
1-1/4” (#12)
Fastener-B
(full threaded)
(Qty 2)
1-1/4” (#12
FASTENER-B
FASTENER-A
8
Measure Diagonal at the corners to check for square.
NOTE: If the diagonals measure the same length, you know that the drop-in panel is square.
9
Install remaining Fastener-A
(11 per side), making sure
not to install a screw into
the 8th hole on each
Aluminum Bracket (9a)
from the “Starting Edge”.
Locate 8th hole on each
side of Aluminum Bracket
from the “Starting Edge”
and install Drop-In Latch
using one (1) Fastener-B
per Latch (9b).
NOTE: Do not tighten all
the way down tight. This
latch needs to be able to
turn to be used as a latch to
the aluminum frame (9c).
Drop-In Latch
(Qty 2)
Note: 1 for each
side (Use in hole
#8 on each
aluminum rail
with Drop-In
Latch (block)
9a
9a
11
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
8b
9b
9b
1-1/4” (#12)
FASTENER-B
DROP-IN
LATCH
DROP-IN
LATCH
A
B
1
A
B
2
9c
DROP-IN
LATCH
DO NOT
FULLY
TIGHTEN