Installation Guide

Tommy Docks 4003 Dixie Ave, Wausau, WI 54401 http://www.tommydocks.com [e-mail]
Phone - 715.842.3804 Toll Free – 866.675.1880 Fax – 715.842.3420
©2017 Tommy Docks® TD-40008 & TD-40010
Insert the center I-Beam into the End Rail as shown. The
top flange of the I-Beam goes on top of the End Rail and
the bottom flange of the I-Beam sits on top of the bottom
flange of the End Rail as in first picture in this step. Insert
the screws and locknuts and hand tighten.
Install one Intermediate Crossmember I-Beam into the
Side Rail, attach with the screws and locknuts then hand
tighten. Notice that the Intermediate Crossmember fits in
between the flanges on the Side Rails but not where it
attaches to the center I-Beam.