Instructions / Assembly

Tommy Docks Bench Assembly and Installation
4' CEDAR BENCH
Part # - TD-10098 dimensions are 48" x 31" x 16"
Tommy Docks bench has been designed to be disassembled without the use of tools, as may be
required for periodic cleaning or end of season storage. By referring to the photograph at the right,
the backrest can be easily removed by lifting the backrest off the dowel shafts located on the seat
assembly. The seat assembly can be easily removed by lifting the seat assembly off the dowel shafts
located on the mount assemblies.
1. Assemble the cedar boards to the seat and backrest assemblies, and the armrests, with the
5/16” x 1-1/4” truss screws. Be sure to note the reference diagram illustrating the different mounting
hole dimensions for the cedar boards.
2. Assemble the backrest assembly to the seat assembly by placing the backrest assembly onto
the seat assembly dowel shafts.
3. Assemble each mount assembly to the seat assembly by inserting the mount assembly dowel
shaft into the seat assembly leg, one each side.
4. Place the bench assembly on the dock in the desired position with the mount assemblies
located on the dock edge and with the mounting holes positioned over the dock surface. Use “C”
clamps to temporarily hold the mount assemblies in position on the dock surface.
5. Using the holes in the mount assemblies as a template, drill a 7/32” pilot hole into the dock
surface at each corresponding hole location.
6. Fasten the mount assemblies to the dock with 5/16” x 1-1/4” hex head lag screws.