Instructions / Assembly

4
Align Axle Mount Entry Plate and 4ft Support Rest with the Rear Trunk Assembly (4a) and secure using two (2)
7” Partially Threaded Bolts, four (4) Flat Washers, and two (2) Nyloc Locknuts (4b).
www.tommydocks.com
Axle Mount
Entry Plate
Rear Trunk Assembly
4ft Support Rest
4a
4b
3
Insert one (1) Axle into each Wheel (14 total) (3a). Secure using one (1) Stainless Steel Retaining Ring for each Wheel
using the Snap-Ring Pliers (3b). Insert all 14 Wheels through the pre-drilled holes located in the Trunk Assemblies
(3c) and fasten them on the bottom side using one (1) Stainless Steel Retaining Ring per Wheel (3d).
Note: the two shorter Axles must be at the far end of the Rear Trunk Assembly.
Note: If an Axle fit is too tight, try a different hole on the Trunk.
3a
Axle
PWC Wheel
3b
Stainless steel
retaining ring
3d
3c
Short PWC Wheels
inserted here
Rear Trunk
Assembly