User Manual

5. Fit the Silencer Band Rubber to the Silencer Band, take care not to scratch
the Silencer when fitting the exhaust.
* Use the supplied Silencer Rubber (Ref ⑨/ ⑩).
6. Take note of the clearance of each section when you are doing up the bolts.
Torque Settings Fitting Nut M12 part (Ref ⑥) [56～94N・m(5.7～9.6kgf-m)]
Torque Settings Clamp band part (Ref ⑧) [25N・m(2.6kgf-m)]
Torque Settings Fitting Bolt M8 part (Ref ⑫) [20～28N・m(2.0～2.9kgf-m)]
7. Use the springs to connect the Main Pipe A/B, Main Pipe B and Silencer ASSY.
*Use the supplied spring (Ref ⑦).
CAUTION!
· Please check all clearances with the vehicles body and make sure that the bolts are not interfering
with anything else. The Main Pipe A requires approx 10cm of clearance from the heat sheild.
If you cannot obtain
that much clearance then try installing without the heat sheild to ensure adequate clearance
is available.
· After fitting the straight pipe and/or catalytic converter please check that there are no signs of oil,
dirt so as not to burn them later when the car is running.
TIP: clean all fingerprints and oil off the Titanium
exhaust before starting the engine.
7. If needed you can then install the sound reducer.
* Use the sound reducer M6 button bolts (previous page⑫/⑬).
Torque Specs [8~12N・m (0.8~1.2kgf-m)]
WARNING
* It is highly recommended not to use the sound reducer when
using the car for high speed/ hard driving as it may cause engine failure.
* Only install or remove the sound reducer when the engine and exhaust is cold to avoid any burns
or injuries.
8. Reconnect the cars battery negative terminal.
INSTALLATION VERIFICATION
1. Check again the vehicle that there are no parts interfering with any other components.
2. Start the engine and let it idle first before taking it up to 2500 RPM to check and listen for any signs
of exhaust leaks or any abnormal sounds. Then recheck the car again for any loose parts or gas leaks.
3. After the initial test drive check the car again for any signs of exhaust gas leakage and any loose
parts, bolts and nuts.
WARNING
· Any interference with any parts/components can pose a fire risk hazard so please meticulously check
the car after the install.
· Any exhaust leaks can decrease performance efficiency and also pose a health risk hazard with toxic
exhaust gas poisoning.
· If there is anything felt abnormal when driving please stop immediately and check the car over.
· When any work or checks are to be done with the metal exhaust components then please do so when
it is cold to prevent any burns and injuries.
· If any parts are lost or have fallen off then does not restart the car until the missing part(s) can be
replaced properly.
7