Manual

11
7. If needed you can then install the sound reducer.
※The Sound Reducer （Page 3, part #⑬)
Button Bolt M6 ( Page 3, part #⑭)
Torque Specs [8～12N・m (0.8～1.2kgf-m)]
WARNING
* It is highly recommended not to use the sound reducer when
using the car for high speed/ hard driving as it may cause
engine failure.
* Only install or remove the sound reducer when the engine and exhaust is cold to avoid any burns
or injuries.
8. Reconnect the cars battery negative terminal.
INSTALLATION VERIFICATION
1. Check again the vehicle that there are no parts interfering with any other components.
2. Start the engine and let it idle first before taking it up to 2500 RPM to check and listen for any signs
of exhaust leaks or any abnormal sounds. Then recheck the car again for any loose parts or gas leaks.
3. After the initial test drive check the car again for any signs of exhaust gas leakage and any loose
parts, bolts and nuts.
WARNING
· Any interference with any parts/components can pose a fire risk hazard so please meticulously check
the car after the install.
· Any exhaust leaks can decrease performance efficiency and also pose a health risk hazard with toxic
exhaust gas poisoning.
· If there is anything felt abnormal when driving please stop immediately and check the car over.
· When any work or checks are to be done with the metal exhaust components then please do so when
it is cold to prevent any burns and injuries.
· If any parts are lost or have fallen off then does not restart the car until the missing parts) can be
replaced properly.
CAUTION
・The vehicles characteristics and exhaust backpressure may change after installing this product so
after the install you may need to have the ECU map settings and fuel supply pressure checked and
adjust accordingly to suit the new setup.