Manual

CAUTION (for BNR34)

There's a chance that the Rear Diffuser may come into contact/interfere with BNR34, depending

on the type of Front Pipe that is used on your setup. Please lower the Rear Diffuser, by using

the supplied Aluminum Spacer, if there is interference/contact made, when you have changed your

Front Pipe, Pront Pipe bracket and cataytic converter/decat pipe.

ACCESSORY

Aluminium Spacer x4

CAUTION

· Please check all clearances with the vehicles body and make sure that the bolts are not interfering

with anything else. The clearances can change from vehicle to vehicle. Be sure that all the bolts are

tightened correctly so that there is no pollution caused form any exhaust leaks.

· After fitting the straight pipe and/or catalytic converter please check that there are no signs of oil,

dirt so as not to burn them later when the car is running.

· After fitting the exhaust, you should check if the rear bumper will

be at risk from heat from the pipe. You may need to add extra heat

shield protection on the rear bumper.

Rear Diffuser

Flange Bolt

Insert the Aluminium

Spacer here.

Triple Cross Bar Installation Bracket

Diffuser

※

※Part

< Figure 1 >

< Figure 2 >

Torque Specs

20.6～26.5 N・m (2.1～2.7kg-m)