Owner's manual

CAUTION

・ Please check all clearances with the vehicles body and make sure that the bolts are not interfering

　with anything else. The clearances can change from vehicle to vehicle. Be sure that all the bolts

　are tightened correctly so that there is no pollution caused form any exhaust leaks.

・After fitting the straight pipe and/or catalytic converter please check that there are no signs of oil,

　dirt so as not to burn/bake it later when the car is running.

TIP: clean all fingerprints and oil off the Titanium exhaust before starting the engine.

INSTALLATION VERIFICATION

1. Check again the vehicle that there are no parts interfering with any other components.

2. Start the engine and let it idle first before taking it up to 2500 RPM to check and listen for any signs

of exhaust leaks or any abnormal sounds. Then recheck the car again for any loose parts or gas leaks.

3. After the initial test drive check the car again for any signs of exhaust gas leakage and any loose parts,

bolts and nuts.

WARNING

· Any interference with any parts/components can pose a fire risk hazard so please meticulously check

the car after the install.

· Any exhaust leaks can decrease performance efficiency and also pose a health risk hazard with toxic

exhaust gas poisoning.

· If there is anything felt abnormal when driving please stop immediately and check the car over.

· When any work or checks are to be done with the metal exhaust components then please do so when it

is cold to prevent any burns and injuries.

· If any parts are lost or have fallen off then does not restart the car until the missing part(s) can be

replaced properly.

CAUTION

・The vehicles characteristics and exhaust backpressure may change after installing this product so

　after the install you may need to have the ECU map settings and fuel supply pressure checked and

　adjust accordingly to suit the new setup.