Owner's manual

1. REMOVAL OF THE STOCK CATALYTIC CONVERTER

This manual only provides the simple instructions. For more details please refer to the vehicles

official service manual.

1. Disconnect the cars battery negative terminal.

2. Remove the stock catalytic converter.

2. TOMEI STRAIGHT PIPE INSTALLATION

【Illustration of the mounting position of each bolt & gasket】

The installation of the bolts included in the kit is shown below.

【MOUNTING INSTRUCTIONS】

1.　Install the straight Each gasket bolt and nut using the supplied straight pipe catalyst installed.

【FRONT EXHAUST PIPE】

* Use the Supplied Gasket Ref ①

　 Torque Settings Nut (Ref ③) [49～69N ・m (5.0～7.0kgf-m)]

【CENTER EXHAUST PIPE】

* Use the supplied Gasket Ref: ①.

　 Torque Settings Nut (Ref ③)　[49～69N ・m (5.0～7.0kgf-m)]

2. Reconnect the cars battery negative terminal.

②※

③

②

※

②※

④

①

④

③

①

④

* Use the bolt smooth paste provided to prevent the bolts from seizures and rust welds

Rear →

← Front

①

Gasket

②

Flange Bolt

③

Nut [49~69N・m (5.0~7.0kgf-m)]

④

Washer