User guide

WARNING Relating to Gasoline

Be careful with handing the fuel during the removal and re-installation of fuel line and components. Since it will be

a high fire and explosion hazard risk, always be sure that there is protection and safety equipement around at all

times.

■

The right place for the job is with the following attribute

① A well-ventilated place.

② Make sure that there is no fire risk hazard tools, equipement near the work space

(lighters, electronic tools, welders).

③ Take precautions so that fuel vapors does not fill the work area.

■

Do not use anything that can cause sparks on the job.

① About electrical machinery and equipement.

・ As a general rule, do not use for this type of job or similar.

・ Do not test the pump and/or fuel in a plastic tank.

・ Do not use a drill, grinder and/or welder.

② Preventing sparks during the job.

・ Keep your work place spark free. (ie. Do not use a hammer).

■ Preventing static electricity, safe practices.

① Have a fire extinguisher prepared.

② Prevent static electricity.

・ Keep the floor slip free and free from water.

・ Keep the vehicles properly earthed when changing the fuel duct and components.

③ Keep the fuel separated when possible during the proceedure.

■ Have the fuel tank emptied before commencing work.

■ Take care not to spill the fuel that is left in the piping when removing the fuel lines.

■ Remove any unwanted foreign objects from the fuel tank when possible.

Removing the gasoline whilst arranging the fuel piping.

①

Remove the fuel pumps coupler.

①

Remove the fuel pumps coupler.

② Remove the fuel filler cap to release the internal pressure from the tank.

③ When the engine dies, crank the engine 3~4 times to get the fuel back into the system.

④ Turn the ignition switch OFF, remove the negative terminal of the battery.