Manual

REQUIRED TOOLS
These tools are the bare minimum required for the job.
MECHANICAL LOCK
Installation Preparation
【Vehicle Installation】
Have the vehicle setup so you can work under the vehicle.
Flathead Screw Driver
[Large] 1
Phillips-Head Screwdriver
[Small] 1
Monkey Wrench x2
Nipper
Pliers ElectricalCrimpingPliers
Jack Stands & Floor Jack
WARNING
When working with an unstable vehicle, will increase the risk
factor of the vehicle dropping on you.
Use a lift or a pit to safely gain access to areas under the car,
Please use a fixed rigid car stand if required.
【Boots Removal】
You'll be working on the rear wheels.
Check the positions of the cylinders, etc.
Pull back the boots far enough to reveal the nut.
14
C
y
linder
Rear
Remove the clamp
Do not reuse the clamp
Clam
p
Cylinder
Boots