FAQ

Trade Name: Tomcat Super Hold Date Last Updated: April 2011
Supplier: Motomco Ltd. Page 2 of 2
TOMCAT
®
SUPER HOLD MSDS
SECTION VI. HEALTH HAZARDS
PRIMARY ROUTE OF ENTRY:
N/A
SIGNS & SYMPTOMS OF EXPOSURE:
None
EMERGENCY FIRST AID PROCEDURES:
Eyes: Flush with cool water for at least 15 minutes.
Skin: Remove glue with mineral spirits. Wash skin with soap and water.
Inhalation: Remove person to fresh air.
Ingestion: Call physician or emergency phone number immediately, Do not give anything by mouth or induce vomiting unless instructed
by physician.
NOTE TO PHYSICIAN:
None
SECTION VII. CONTROL & PROTECTIVE MEASURES
RESPIRATOR TYPE:
Not required
EYE PROTECTION:
Not required
GLOVES (Recommended):
Not required
VENTILATION:
Not required
OTHER PROTECTIVE MEASURES:
Not required
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA) RATINGS:
HEALTH: 0 (Minimal) FIRE: 0 (Will not burn) REACTIVITY: 0 (Stable) SPECIFIC HAZARD: None
HAZARDOUS MATERIALS IDENTIFICATION SYSTEM (HMIS) RATINGS:
HEALTH: 0 (Minimal) FLAMMABILITY: 0 (Minimal) REACTIVITY: 0 (Minimal) PROTECTIVE EQUIPMENT: None
SECTION VIII. SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN THE EVENT MATERIAL IS RELEASED OR SPILLED:
General clean-up. Remove glue by applying mineral spirits to spilled area, follow up by washing area with warm water and detergent.
WASTE DISPOSAL METHOD:
Wastes resulting from use may be disposed of on-site or at an approved waste disposal facility. Dispose of wastes in accordance with all
applicable Federal, state and local regulations.
SECTION IX. SPECIAL PRECAUTIONS & STORAGE DATA
STORAGE TEMPERATURE:
Room temperature
AVERAGE SHELF LIFE:
Stable
SPECIAL SENSITIVITY (HEAT, LIGHT, MOISTURE):
None
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE:
Store in original container in a cool, dust-free environment. Wash thoroughly with soap and water after handling.
SECTION X. SHIPPING DATA
DOT SHIPPING NAME:
None required
DOT HAZARD CLASSIFICATION:
Non-hazardous
DOT LABELS REQUIRED:
None required
FREIGHT CLASSIFICATION:
LTL Class 60
WARRANTY:
The information provided in the Material Safety Data Sheet has been obtained from source believed to be reliable. Motomco, Ltd. provides no warranties, either expressed or
implied, and assumes no responsibility for the accuracy or completeness of the data contained herein. This information is offered for your consideration and investigation.
The user is responsible to ensure that they have all current data relevant to their particular use.