Use and Care Manual
Page 11 of 23
1.
Put a desired length screed board on solid ground.
2.
Locate the screed head in the middle of screed board by the holes in the rear flange of the board.
3.
Attach the screed to the rear flange of the screed board with bolts and nuts (see the Screed
Board section of the parts list). Tighten the bolts and nuts with 87.3 lbf-ft (1200 kgf-cm) of torque.
4.
For the TVSA-H model with a Honda Engine. Attach desired screed board with 4 bolts to
assembly. Next adjust handles to desired position with Allen wrench. Last, tighten accelerator to
handle position.
Preparation for operation
1)
Check all bolts, nuts and belts and tighten any that are loose.
2)
Get the desired length of screed board.
Recommended Fuel
1) The screed engine requires regular unleaded gasoline. Use only fresh, clean fuel. Fuel containing
water or dirt will damage the fuel system. Consult engine owner’s manual for complete fuel
specifications.
Before starting Engine
1)
Read and understand the safety and operating instructions manual for the engine.
2)
Check :
Oil level in engine.
Fuel level.
Condition of air cleaner.
Tightness of external fasteners.
Condition of fuel lines.
Wear of spark plug
Assembly Instructions
Before Each Use