TWG210A Operations Manual

KNOW YOUR CROSS VALVE “+”

INSTALLATION

1. INSTALLATION OF TIG TORCH

1.1 Remove the ground cable and the electrode holder from the weld output connections. Install

the ground cable to the Positive (+) weld output connection.

1.2 Secure the ground clamp to the work piece

1.3 Connect a regulator to a bottle of ARGON gas. Then connect the gas connection from the

TIG torch to the regulator.

1.4 Connect the TIG torch weld cable to the Negative (-) weld output connection.

1.5 Set desired amperage on the amperage control knob on the front panel of the welder.

1.6 Turn on the input power switch on the welder.

CAUTION

Be aware that the TIG torch will be electrically HOT when the Input Power Switch on the welder

is turned on.

1.7 Turn on the regulator on the bottle of shielding gas and adjust the regulator to approximately

20CFH. Then open the shielding gas valve on the torch to start the flow of shielding gas.

MAINTENANCE

• Maintain your TIG TORCH. It is recommended that the general condition of TIG TORCH be

examined before it is used. Keep TIG TORCH in good repair byadopting a program of

conscientious repair and maintenance. Have necessary repairs made by qualified service

personnel.

• Periodically clean dust, dirt, grease, etc. from your torch.

• Replace power cord, ground cable, ground clamp, or electrode assembly when damaged or

worn