Use and Care Manual

52
3. Pull the steering column handle down to lower the platform.
4. Replace the two bolts locking the platform to each side of the rear frame.
Maintaining the Seat and Seat Belt
Background
In order for the seat and seat belt to operate safely and properly over a long period of time,
periodic maintenance and occasional repairs are necessary. Poorly maintained equipment can
become a safety hazard!
Maintaining the seat and seat belt
 Keep the seat clean. Dirt, dust, or harsh chemicals can damage the upholstery. Repair holes
or tears immediately.
 If necessary, clean the seat belt with a mild soap solution. Do not use chemical cleaners, as
they will damage the fabric.
 Replace the seat belt immediately if it becomes worn or damaged. Otherwise, replace the seat
belt every three years.
 Periodically test the operation of the seat tension knob and the front-to-back lever. Repair or
replace worn or malfunctioning components.
 If the seat does not move smoothly during adjustment, apply a small amount of standard
bearing grease (such as Shell Gadus
®
S2 V100 or equivalent) to the rails.
Hydraulic Oil Level
A hydraulic oil level sightglass (29) is located on the side of the hydraulic fluid reservoir.
While the machine is turned off, check that the hydraulic oil level is visible at the middle level or
higher in the sightglass. If it is not, add oil through the filler port (20) inside the engine
compartment. Use only clean hydraulic oil.
Thoroughly clean the top of the filler cap before removing it from the tank. Care should be taken to
prevent small dirt particles from entering the system.
If hydraulic oil continually needs to be added, inspect hoses and connections for possible leaks.