Use and Care Manual

42
Preliminary Checks
Requirements
Machine on a flat, level surface
Before starting
Before starting the machine, check the following items:
 Engine coolant level
 Engine oil level
 Hydraulic oil level
 Fuel level
 Condition of oil cooler and radiator cooling fins
 Water level in tank
NOTICE: Top off the lubricating and hydraulic oil levels using products
with the grades and specifications shown in the “Lubricants” table
found in the Technical Data chapter of this Operator’s Manual. When
doing so, use clean containers, funnels, etc., to avoid contamination.
Before operating
Before operating the machine:
 Check the machine for fluid leaks. Repair them before operating.
 Unlock the articulated joint.
 Adjust drum scraper position.
 Check the work area for obstructions. Remove all obstructions.
 Check that all handles, steps, and platforms are free of dirt, snow, grease, fuel, or
anything else which might endanger operator safety.
 Allow the engine to warm up according to the following schedule:
Ambient Temperature
Time (min.)
Above 0°C (32°F)
5
Below 0°C (32°F)
15*
* More time may be required if hydraulic controls are sluggish.