Use and Care Manual

28
Roll Over Protection Structure (ROPS)
Background
The machine is equipped with a Roll Over Protection Structure (ROPS). The ROPS is
designed to protect the operator in a rollover accident. Depending on the machine model,
the ROPS is either fixed (stationary) or foldable.
A foldable ROPS is equipped with two sets of hinge pins, or locking pins. This enables the
ROPS to be folded either forward or backward as required for transportation or storage.
WARNING
Crushing hazard. Without a ROPS, you may be crushed if the machine
rolls or tips.
 Never operate the machine without the ROPS in place and
securely fastened in the upright position.
WARNING
Crushing / machine damage hazards. The ROPS is intended strictly to
protect the operator during a rollover or tip-over incident and must not
be used to lift the machine.
 Use only the designated lifting eyes to lift the machine.
WARNING
Personal injury hazard. The ROPS is not a handhold for passengers.
Passengers can be seriously injured or killed from falls, tip-overs, or
roll-over incidents.
 Do not allow anyone to ride on any part of the machine.
Checking ROPS condition
Each month, check:
 the torque on all of the screws holding the ROPS in place
 the ROPS frame for rust, cracks, and any other damage
Rules for reinstalling
When reinstalling the ROPS:
 Use the original nuts and bolts.
 Tighten the bolts to the specified torques.
NOTICE: Do not weld or drill into the ROPS. Drilling or welding on the
ROPS will nullify the ROPS certification.