Operations Manual

SPRAYER CLEANING AND STORAGE

Sprayer Cleaning

Immediately after each use of your Tomahawk $CEMRCEM Sprayer it is important to clean it

properly. Fill the EJGOKECN tank of the sprayer with  gallons of ENGCPwater. Start the engine

and proceed to spray the water into a waste receptacle. Routine cleaning will help to clean out

the sprayer’s pump, hoses, and spraying attachments – while reducing the chances of the

system clogging.

DO NOT use Xylene or any explosive chemical in the cleaning process. This

DCEMRCEM sprayer is meant for use with water-based or waterborne

compounds only. Do not spray solvent-based or explosive liquids with this

sprayer. Failure to comply may cause serious bodily harm or death.

Sprayer Storage

(QTNQPIVGTOUVQTCIGQHVJGURTC[GTHKTUVRGTHQTOCNNTGIWNCTOCKPVGPCPEGRTQEGFWTGUCPF

PGGFGFTGRCKTU

 Empty the fuel tankKPCHWGNUCHGTGEGRVCENG.

 Disconnect the fuel supply line from the carburetor and depress the primer bulb until fuel

stops discharging from the fuel-return line.

 Start the engine and allow it to run until it stops.

 Pull the starter cord a few times to remove any excess fuel from the engine.

 Remove the spark plug and insert a small amount of oil into the cylinder.

 Slowly pull the starter cord and bring the piston to a position closest to the spark plug hole.

 Re-install the spark plug.

 #pply a thin coating of oil to all the metal surfaces and store the URTC[GT in a dry place.