Use and Care Manual
8
A nameplate listing of the model number and serial number
is attached to each unit. Please record the information found
on this plate so it will be available if the nameplate is lost or
damaged. When requesting service information, the serial
number should be specified in the unit.
2. OPERATION
2.1 Operating Principle
The following instructions were compiled to provide you information on how to obtain
long and trouble free use of the unit. Periodic maintenance of this unit is essential. Read
the manual in its entirety and follow the instructions carefully. Failure to do so may
injure yourself or a bystander.
2.2 Delivery Checks
Immediately on taking delivery of your new equipment and before putting it into ser-
vice.
-Read the operation manual completely—it could save a great deal of unnecessary
expense.
-Read the engine manual supplied.
-Check the general condition of the equipment –has it been damaged during delivery?
-Check engine oil level.
-Check fuel levels.
Recommended lubricants are detailed in the Care and Maintenance section.
2.3 Before Starting
The following pre-start-up inspection must be performed before the start of each work
session or aer every four hours of use, whichever is first. If any issue is discovered, the
compactor must not be used until the issue is fixed.
1. Thoroughly inspect the compactor for signs of damage. Make sure all components are
present and secure. Pay special attention to the belt drive safety guard fitted between
the engine and the vibrator unit.
2. Check the engine oil and fuel levels and top o as necessary.