Warranty

2. REDUCTION GEAR OIL (Only on equipped model)
<I /2 reduction with automatic centrifugal clutch>
1. Remove the oil filler cap and wipe the dipstick clean.
2. Insert the dipstick into the filler neck but do not screw it in.
3. If the level is low, fill to the upper level mark with the same oil recom-
mended
for the engine (see engine oil recommendations on page 7).
Oil capacity: 500 cc (1 7 US 02, 14 ImD 02)
UPPER LEVEL
< 1 /6 reduction>
1. Remove the oil level bolt.
p=-y
DIPSTICK/FILLER CAP
DRAIN BOLT
2. Check the oil level; it should reach the edge of the oil level bolt hole. If
the oil level is low, remove the filler bolt, and add
oil until it starts to
flow out the
oil level bolt hole. Use the same oil recommended for the
engine (see engine oil recommendations on page 7).
3. Install the oil level bolt and filler bolt. Tighten them securely.
Oil capacity:
150 cc (5.1 US 02, 4.2 Imp 02)
OIL LEVEL BOLT
FILLER BOLT