Warranty

3. BATTERY CONNECTIONS
(for electric starter)
Use a 12 volt battery with an ampere-hour rating of at least 18 AH.
Connect the battery positive (+) cable to the starter solenoid terminal, as
shown.
Connect the battery negative
(-1 cable to an engine mounting bolt, frame
bolt, or other good engine ground connection.
Check the battery cable connections to be sure the cables are secured and
free
of corrosion. Remove any corrosion and coat the terminals and cable
l ends with grease.
,STARTER
SOLENOID
' POSITIVE (+I BATTERY
CABLE
the battery gives off explosive gases; keep sparks, flames and cigaret-
tes away. Provide adequate ventilation when charging or using bat-
keries
in an enclosed space.
The battery contains sulfuric acid (electrolyte). Contact with skin or
pyes may cause severe burns. Wear protective clothing and a face
Fhield.
!- If electrolyte gets on your skin, flush with water.
~- If electrolyte gets in your eyes, flush with water for at least 15
~ minutes and call a physician immediately.
~- If swallowed, drink large quantities of water or milk and follow with
I milk of magnesia or vegetable oil and call a physician.
0 Electrolyte is poisonous.
!KEEP OUT OF REACH OF CHILDREN.
I NOTICE I
0 use only distilled water in the battery. Tap water will shorten the ser-
vice life of the battery.
filling the battery above the UPPER LEVEL line may cause the elec-
~trolyte to overflow, resulting
in corrosion to engine or nearby parts.
~lmmediately wash off any spilled electrolyte.
0 be careful not to connect the battery in reverse polarity, as this will
;short circuit the battery charging system.