Warranty

<Oil bath type>
1. Unscrew the wing nut, remove the air cleaner cover and remove the
element.
2. Wash the element in a solution of household detergent and warm
water, then rinse thoroughly, or wash
in nonflammable or high flash
point solvent. Allow the element to dry thoroughly.
The engine will smoke during initial start-up if too much oil is left
in the
element.
4. Empty the oil from the air cleaner case and wash out any accumulated
dirt
with nonflammable or high flash point solvent. Dry the case.
5. Fill the air cleaner case to the level mark with the same oil that is recom-
mended for the engine (see engine oil recommendations on page
7).
6. Reinstall the element and the cover.
3. Soak the element in clean engine oil and squeeze out the excess oil.
OIL CAPACITY: 60 cc (2.0 US 02, I .69 Imp 02)
AIR CLEANER COVER
ELEMENT
24