Use and Care Manual
Operator’sManual 33
5.5 Exciter V-belt
It is not necessary to retighten the V-belt owing to the use of the automatic centrifugal
clutch.
Should the V-belt width fall below 15,5 mm the V-belt must be replaced.
5.5.1 Changing the exciter V-belt:
1.
Remove belt guard (5) by removing the Bolt on both side
s
2.
Undo screw (3
0).
3.
Remove the centrifugal clutch (31) from the engine along with belt (32) and rotate th
e
e
xciter pulley for the trouble free operation
4.
Change exciter V-bel
t (32).
5.
Assemble the components in reverse order; make sure that the Bolt tighteni
ng the
clut
ch had attained to full torque limit.
Do not oil or grease clutch components (will damage the graphite bushes).